High Pressure, Plural Component, Direct Impingement Mix, Mechanical Purge
The MG Spray Gun is extremely simple to operate and it is the most compact, lightest weight, most maneuverable spray gun, with the lowest parts count in the industry.
TECHNICAL INFORMATION
Features
- Simple operation, easy set-up and maintenance
- Versatile – Sprays Polyurea Coatings, Urethane, and Spray Foams
- Inexpensive to service, industries lowest rebuild cost
- Less than 5 minute clean up at the end of the day
- Requires 3 minutes to change PCD
- Will dispense materials at 1:1 through 4:1 ratios
- Round Spray Pattern, Variable Flow rates from 1 lb/min to 23 lbs/min
- Excellent Mix
- Lowest Cost Mix Package (pattern control disc mix module)
- Adapter blocks and fittings to connect to any make of proportioner
- Coupling Block with material shut-off valves allows leakage free disconnect from gun
- Extremely flexible 24” whip hoses save flexing wear of your heated whip hoses
- Valving Rod & PCD require no adjustment
- Rebuild-able check valves
Applications
- Shipboard / Offshore
- Refinery / Pipe / Tank
- Bridge / Architectural
- Truck Bed Liners
- Automotive Ground Effects
- Secondary containment
- In Mold Coatings, Scenic Theaming and Fabrication for the Theme & Prop Industry
- Foam Insulation and Roofing
- EPS hard-coating
Specifications
- Introduced in 2010
- High Pressure, Plural Component, Direct Impingement Mixing, Mechanical Purge
- Minimum Material Output: 1lb./min (.4536 kg)
- Maximum Material Output: 23 lbs./min (10.43 kg)
- Small Size:
- Height: 6 ½” (16.51 cm)
- Width: 2” (5.08 cm)
- Length: 2 ¾” (6.99 cm)
- Weight: 1.9Lbs. (0.86kg)
- Spray Tip to Rear of Gun: 3 1/8″ (7.94cm)
- Air Requirement: 80-130 PSI (0.56 – 0.9 MPa, 5.6 – 9.0 bar)
- Maximum Fluid Temperature: 200°F (94°C)
- Maximum Fluid Working Pressure: 3500 psi (24.5 MPa, 245 bar)
